Can not be used normally when the decocting machine squeezes the device and rotates the handwheel
1. During the decocting process, when the handwheel rotates, it feels very laborious or does not turn at all. At this time, it is proved that the bearing inside the upper end of the squeezing rod lacks lubricating oil or the bearing is damaged, and the lubricating oil or the bearing should be replaced.
2. During the extrusion process, there will be obvious air leakage when the hand wheel rotates. At this time, it is proved that the internal PTFE gasket is damaged and needs to be replaced immediately.
Decoction machine decocting cap leaking
1. There are two kinds of locking mode for the top of the decocting machine: the sliding and locking handles respectively, the leakage condition of the sliding is small, and the leakage of the locking handle is generally because there is no fastening or no even tightening, and the handle is re-applied. It can be solved by tightening or diagonally fastening.
2. The seal ring under the decocting lid is aging or damaged, and the sealing ring is replaced. After the seal is aged, it is impossible to perform a complete seal, which may cause direct leakage during the decoction. At this time, we should check whether the seal is aging or damaged.
1. During the decocting process, when the handwheel rotates, it feels very laborious or does not turn at all. At this time, it is proved that the bearing inside the upper end of the squeezing rod lacks lubricating oil or the bearing is damaged, and the lubricating oil or the bearing should be replaced.
2. During the extrusion process, there will be obvious air leakage when the hand wheel rotates. At this time, it is proved that the internal PTFE gasket is damaged and needs to be replaced immediately.
Decoction machine decocting cap leaking
1. There are two kinds of locking mode for the top of the decocting machine: the sliding and locking handles respectively, the leakage condition of the sliding is small, and the leakage of the locking handle is generally because there is no fastening or no even tightening, and the handle is re-applied. It can be solved by tightening or diagonally fastening.
2. The seal ring under the decocting lid is aging or damaged, and the sealing ring is replaced. After the seal is aged, it is impossible to perform a complete seal, which may cause direct leakage during the decoction. At this time, we should check whether the seal is aging or damaged.
Surgical Face Mask,Civil Protection Mask,Ladies Mask CE 2163 MA-001,5 Ply Protection Face Mask
Zhejiang Minan Medical Supplies Co.,Ltd , https://www.minanmask.com