1. Cancellation cannot be premature. When the side branch of the tomato is too small, it produces more nutrients than the nutrients consumed, so it should not be removed at this time, especially when the leaves of the plant do not completely cover the ground. In order to make full use of the nutrition produced by the side branches, it is better to remove the side branches when the length is about 5 cm. For the first branch of the lower part of the flower per tomato, it should be properly removed early, and should be removed when the length is about 3 cm. If the first side branch of the lower part of the flower of the tomato is not removed in time, the growth will soon exceed the main branch, thus causing a large amount of nutrient waste.
2, the evacuation can not be too late. If the side branch of the tomato is removed too late and the side branch is more than 5 cm long, it will compete vigorously with the main branch for nutrients, and the growth will gradually exceed the main branch. Too late collateral branching will also cause aging of the phloem of the lateral branches. Because the lateral branches are closely connected with the phloem of the main branches, the epidermis of the main branches is easily broken when the lateral branches are removed, which affects the growth of the tomato. In addition, when the side branches of the tomato are removed, the pile cannot be left in order to prevent the side branches from being germinated again from the same leaf axils.
3. Spray protection after evacuation. If not protected after the removal, the bacteria will infect the wound. Therefore, after the thinning, a new high-fat film is sprayed in time to form a polymer film to isolate the pests and diseases of the pests and diseases from the wound.
Disclaimer: Some articles on this website are transferred from the Internet. If legal rights of third parties are involved, please inform this website. phone
Solar Energy Hardwares
Channel nuts are used with Channel Support Systems. The grooves along the edges act as small teeth that can lock onto the channel when tightened. Channel systems are designed for multiple applications, including supporting containment and pipe brackets for all types of electrical and mechanical installations and are a key part of making sure all the infrastructure stays together.
Yokelink Channel Nuts made by carbon steel or Stainless Steel. Nut size 34.5X19 mm, thickness could be 6 mm, 8mm, 9mm, 10mm, 12mm. Zinc plated or Hot Dip Galvanized finish. For different applications, you need different types of nuts. All Yokelink's channel nuts are available in M6, M8, M10 and M12 .Find out from us for the different variations of channel nuts for your application.
Solar Energy Hardware,Spring Channel Nut,Solar Mounting Channel Nut,Stainless Steel Spring Nut
Ningbo Yokelink Machinery Co.,Limited , https://www.yokelink.com