Beating Sterile Homogenizer Instructions

First, the use of tapping aseptic homogenizer

1. Put the sample to be processed into a sterile homogenized bag.

2. Open the homogenizer door ( can be fully opened ) and clamp the sterile bag opening when closing the homogenizer door.

3. Set the usage program ( such as the slap speed, slap time, etc. ) to perform the slap homogenization work.

4. After the experiment is completed, open the homogenizer door and take out the sample.

Second, tapping type aseptic homogenizer use precautions

1, the power cord must be plugged tightly in place may loosen due impact crashes computer controller, such as a crash phenomenon, turn off the rear power switch off 3 minutes after restart.

2, Do not open the door when working in a homogenizer hammer plate, the sample liquid to avoid overflow. It should be built according to “on / off” and the equipment will stop running automatically. When the door is closed, press “Open / Stop” to build, and the device will automatically complete the remaining work.

3, instrument unused for long periods should cut off the power dial to plug.

4 , the bottom of the door to prevent accidental rupture of the homogenized bag, easy to clean spills, the bottom design is empty, you can place the water tray, so do not extend your hand from the bottom when the instrument is running, so as not to scratch your fingers.

5, before the operation, check whether the foreign body inside homogeneous, so as not to damage and failure occurs when the bags homogeneous work.

6 , lumps, bone, ice-like substances should not be used, so as not to damage the homogenized bag.

7, apparatus and homogeneous storage bags should avoid direct sunlight, especially homogeneous bags should be stored in the absence of sunlight or ultraviolet radiation to avoid the place, in order to avoid aging.

8, when a small amount, it takes speed, when the fiber tough homogeneous mass, back slap Knob adjusting plate and the spacing window to achieve better results homogeneous.